References
252
Gryphon™ I GFS4170/GFS4150-9
Table 33. Good Read LED Duration Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting
Good Read LED
stays on until next
trigger pull (00)
20ms 150ms 2550ms (2.55 sec.)
2
Divide by 10 (and pad with
leading ze
roes)
000 002 015 255
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan LABEL GOOD READ LED DURATION
5
Scan Three Characters From
Appendix D, Keypad
‘0’, ‘0’ and ‘0’ ‘0’, ‘0’ and ‘2’ ‘0’, ‘1’ and ‘5’ ‘2’, ‘5’ and ‘5’
6 Scan ENTER/EXIT PROGRAMMING MODE
Scanning Features
Operating Mode
The following Operating Modes (Reading Modes) are supported:
On Line
In On Line mode, the reading phase is defined as the time between the Phase ON and Phase
OFF events. The Phase events can be generated by an external input (trigger) or by the Trigger
button. While in this mode the scanner activates reading only during a reading phase. The
Phase events can be signals coming from the trigger button (or external presence sensor
connected to the scanner input for RS232 models).
On Line mode allows the following configurations:
Phase Off Event:
Specifies whether the reading phase is closed on a timeout or phase off event.
The following selections are available:
• Trigger Stop: the reading phase ends when the trigger event stops. Timeout is disabled.
• Timeout: the reading phase ends when the timeout is expi
r
ed. Trigger stop is ignored.
• Trigger Stop - Timeout: the reading phase ends when the first event occured.
Timeout:
Specifies the maximum duration for the reading phase. Selections: from 40 to 5100
ms in 20 ms increments
Serial On Line
In Serial On Line mode, a reading phase is defined as the time between two events: phase on
and phase off, generated by a message sent from the host interface to the scanner. While in this
mode the scanner activates reading only during a reading phase. The message (character or
string) is user programmable.
Serial On Line mode configurations:
To Next Page
Loading...
