Data Format ENTER/EXIT PROGRAMMING MODE
50
Gryphon™ I GFS4170/GFS4150-9
Label ID Symbology Selection — continued
Set DataBar Limited Label ID Character(s)
Set Code 93 Label ID Character(s)
Set MSI Label ID Character(s)
Set Plessey Label ID Character(s)
Set Global Mid Label ID Characters
Specifies mid-label ID that is added for transmission between the labels of a two-label pair.
Set Global Mid Label ID Character(s)
To configure this feature, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix
D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
sa
ve the entry string. You can then start again at the beginning.
CANCEL
No Mid Label ID
Character (00)
To Next Page
Loading...
