ENTER/EXIT PROGRAMMING MODE No Read String
Product Reference Guide
51
No Read String
This feature defines the string or character to be displayed in case of No Read during a reading
phase (in On Line Mode only). It allows up to 20 characters, from the set of ASCII characters or
any hex value from 00 to FE.
Select No Read String
To configure this feature, scan th
e ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix
D, Keypad
representing your desired character(s). If less than
the expected string of 20 characters are selected, scan the
ENTER/EXIT b
arcode to terminate the string.End by scanning
the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
s
a
ve the entry string. You can then start again at the beginning.
CANCEL
See No Read String on page 248 for more information on setting this feature.
To Next Page
Loading...
