Data Format ENTER/EXIT PROGRAMMING MODE
44
Gryphon™ I GFS4170/GFS4150-9
GS1-128 AIM ID
If Global AIM ID is disabled, the AIM ID for GS1-128 can be enabled/disabled independently.
The AIM ID for GS1-128 is a ]C1, ]C2 or ]C3.
AIM IDs for other symbologies can be enabled/disabled independently as well
. Contact
Customer Support for assistance
GS1-128 AIM ID = Disable
GS1-128 AIM ID = Enable
Label ID
A Label ID is a customizable code of up to three ASCII characters (each can be one of hex 0x01-
0xFF), used to identify a barcode (symbology) type. It can be appended previous to or following
the transmitted barcode data depending upon how this option is enabled. This feature provides
options for configuring custom Label IDs as a pre-loaded set (see "Label ID: Pre-loaded Sets"
below) or individually per symbology (see "Label ID: Set Individually Per Symbology"on
page 45). If you wish to program the reader to always
include an industry standard label
identifier for ALL symbology types, see the previous feature "Global AIM ID"on page 43.
See Label ID, starting on page 244 of “References” for more information on setting this feature.
Label ID: Pre-loaded Sets
The reader supports two pre-loaded sets of Label IDs. See Label ID: Pre-loaded Sets, starting on
page 244 for details on the USA set and the EU set.
CAUTION
When changing from one Label ID set to another, all other reader configu-
ration settings, including the host interf
ace type, will be erased and set to
the standard factory defaults. Any custom configuration or custom defaults
will be lost.
To Next Page
Loading...
