ENTER/EXIT PROGRAMMING MODE Sleep Mode Timeout
Product Reference Guide 63
Sleep Mode Timeout
This feature sets the amount of time that the reader will be idle before it enters into a low power
Sleep Mode. When in Sleep Mode the reader can no longer receive commands from the Host or
base station until it is woken up again, either by a trigger pull or when an external trigger event
occurs.
See page 254 in “References” for more information about this feature.
Sleep Mode Timeout = Disable
DEFAULT
Sleep Mode Timeout = 10 Seconds
Sleep Mode Timeout = 30 Seconds
Sleep Mode Timeout = 1 minute
Sleep Mode Timeout = 5 minutes
Sleep Mode Timeout = 10 minutes
This feature is available only for the GFS4150-9 (RS-232 interface) in On Line
operating mode.
To Next Page
Loading...
