Reading Parameters ENTER/EXIT PROGRAMMING MODE
72
Gryphon™ I GFS4170/GFS4150-9
Phase Off Event
Trigger Stop
DEFAULT
Timeout
Trigger Stop - Timeout
Phase Off Timeout
Timeout can be set within a range of 40 milliseconds to 5100 milliseconds (0.04 to 5.1 seconds)
in 20 ms increments.
Select Phase Off Timeout
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
100 = Timeout set on for 2 seconds
To Next Page
Loading...
