ENTER/EXIT PROGRAMMING MODE Match String
Product Reference Guide
53
Match String
This feature allows you to define the string to be used as the match code for Code Verification.
The Match String must be configured to include start/stop characters and check digits if their
transmission is enabled. See page 249 in “References” for more information.
It is possible to define the Match string by inserting:
•
all printable characters
• non printable ASCII characters
No wild card characters are supported.
Set Match String
To configure this feature, scan th
e ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix
D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
sa
ve the entry string. You can then start again at the beginning.
CANCEL
To Next Page
Loading...
