Site Preparation and Installation
20 Magellan
®
2200VS/2200VS and 2300HS/2300HS
Installation: Model 2300HS
The Magellan
®
2300HS scanner is mounted flush with the countertop to
promote comfortable and ergonomic slide-through scanning. Installation
as described below.
1. Determine the best location for scanner. Some considerations are:
• Proximity to the user. Verify that checkstand features allow the
unit to be within easy reach of the user, without interfering with
cash drawers or other equipment.
• Cable routing to and from the scanner: Can cables and connected
devices be routed in such a way as to be protected from damage or
tampering?
• Mounting stability. Avoid placing the scanner in such a way as to
subject it to excess vibration, bumping, spillage, etc.
• Peripheral connections from the scanner, such as a handheld
device.
2. The countertop must be modified to accept the scanner. At the time
of this writing, three options are available.
—
Figure 2-3a shows the dimensions for the opening and other
details if a shelf is to be built to support the unit.
—
Figure 2-3b details the cutout dimensions if an adapter fixture
holding the scanner will rest with its rim above the countertop.
—
Figure 2-3c provides dimensions if an adapter fixture holding
the scanner will be recessed to be flush with the countertop.
3. Remove the Connector Cover, then connect and route the cables at
the scanner. Reference
Figure 2-4.
4. Seat the scanner or in the countertop opening (or adapter).
5. Switch the terminal OFF.
6. Connect the interface cable to the terminal.
7. Connect the scanner’s AC Adapter to the AC outlet.
8. Switch the terminal ON.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
