Datalogic Magellan 2300HS User Manual

EAS Features
Product Reference Guide 81
EAS Timeout
Specifies the amount of time that an EAS (Electronic Article Survellance)
signal is held in its active state for a good read indication.
To set the EAS Timeout:
1. Scan the SWITCH bar code.
2.Scan the bar code, SET EAS TIMEOUT below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3.Scan the appropriate digits from the keypad in
Appendix C that
represent the desired EAS Timeout duration. The selectable range
is 0-255, which is the timeout in 10-millisecond increments. Pad
all single and double digit numbers with leading zeroes to yield a
three-digit entry (000-255).
Examples:
000 = EAS timeout disabled
001 = 10ms
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
4.Scan the SWITCH bar code to exit Programming Mode.
SET EAS TIMEOUT
NOTE
A setting of 0 (000) disables this feature.

Datalogic Magellan 2300HS Specifications

General

Scanner type	1D
Decoding standards	GS1 DataBar
Input voltage	90 - 265 V
Power requirements	47-63 Hz
Power consumption (standby)	2.5 W
Dimensions (WxDxH)	152 x 152 x 86 mm
Certification	RoHS
Product color	Gray
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	1100 g