Datalogic PowerScan M8300 User Manual

POWERSCAN
®
D8330/M8300/M8300-DK
194
5.17.2 Scanner Code ID
The default Data Format is valid for all M8300 models. Code Identifer and Code len
TX (on pages 71,76 in this manual) are also valid for DK models. The item
configuration is part of the cradle configuration and is applied to the scanner system.
Optionally, the DK 16-key scanner can be set for:
• Scanner Code ID
• Scanner Code Len TX
(with the same optional values as for standard formatting)
Differently from the other DK formatting, these two configuration items have priority
over the corresponding standard formatting, and hide or substitute for them.
As a result the M8300-DK can have the following configuration scenarios:
Scanner Code ID = Disable
The settings from the standard Code ID on page 71 will be used (if programmed).
Scanner Code ID = any different value from Disable (option 1,2,3 – Datalogic
standard, AIM standard, or custom)
Use the specific DK Scanner Code ID instead of the standard Code ID. DK Scanner
Code ID will be applied and will take priority over any standard Code ID settings,
even if programmed.
5.17.3 Scanner Code Length
The behavior of Scanner Code Length is similar to that described above for Scanner
Code ID.
As a result the M8300-DK can have the following configuration scenarios:
Scanner Code Length = Disable
The settings from the standard Code Len TX on page 76 will be used (if
programmed).
Scanner Code Length = any different value from Disable (variable digit format,
fixed digit format)
Use the specific DK Scanner Code Length instead of the standard Code Len TX.
Scanner Code Length will be applied and will take priority over any standard Code
Len TX settings, even if programmed.
NOTE: Both of these configuration items are part of the scanner configuration but are
applied to the whole system. The configuration item overwrites the default Data
Format .

Datalogic PowerScan M8300 Specifications

General

Scanner type	1D
Maximum range	30 m
Read rate (max)	40 reads/s
Yaw reading angle	-60 - 60 °
Decoding standards	GS1 DataBar, Code 16K, Code 49, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked, GS1 DataBar Stacked Omnidirectional
Tilt reading angle	-20 - 20 °
Pitch reading angle	-55 - 55 °
Operating time	240 min
Dimensions (WxDxH)	114 x 69 x 210 mm
Bluetooth	No
Operating frequency	910 MHz
Input voltage	10 - 30 V
Battery capacity	2150 mAh
Power requirements	0.33 - 1A
Number of reads per charge	60000
Certification	IP64, China RoHS, EU RoHS, CDRH Class II, IEC 60825-1 Class 2
Keys quantity	3 keys
Product color	Black, Yellow
LED indicators	Charging, Power
Display resolution	32 x 96 pixels
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 90 %

Weight and Dimensions

Weight	393 g