POWERSCAN
®
D8330/M8300/M8300-DK
6.
Set Radio Address
+
four digits from the Numeric Table in the range 0000-1999.
All readers must have different addresses.
7.
First STAR-System™ Address
Read the code above and the four-digit address
of the First STAR-System™
8.
Set Last STAR-System™ Address
Read the code above and the four-digit address
of the Last STAR-System™
Whenever the system is composed of a single base station, the
first and last base station addresses (steps 7 and 8) must have
the same value.
NOTE
9.
Exit and Save Configuration
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see par. 4.10.
To Next Page
Loading...
