Datalogic PowerScan M8300 User Manual

POWERSCAN
®
D8330/M8300/M8300-DK
34
5.
Read the BC-8060 restore default code:
Restore BC-8060 Default
Ì$+RX0$-qÎ
6.
Read the desired Enable Network code.
Enable RS-485 Master
Ì$+RZ2$-ÇÎ
Enable RS-485 Slave
Ì$+RZ1$-~Î
END of procedure.
For Host Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed through STAR-Link™ software running on the PC.
Star-Link™ software can be downloaded for free from the web site:
www.scanning.datalogic.com.
For BC-8060 Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed either through the Datalogic Aladdin™ configuration
software running on the PC or by reading the barcode selections in the Network
section of this manual starting on page 64. If using configuration barcodes, it is
advised to completely configure the cradles before reconfiguring the PowerScan
®
M8300 reader (see below).
After completing the BC-8060 cradle c
onfiguration and
connections in the network, you must reconfigure the
PowerScan
®
M8300 reader using the STAR-System™ procedure
in par.
4.6.
NOTE

Datalogic PowerScan M8300 Specifications

General

Scanner type	1D
Maximum range	30 m
Read rate (max)	40 reads/s
Yaw reading angle	-60 - 60 °
Decoding standards	GS1 DataBar, Code 16K, Code 49, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked, GS1 DataBar Stacked Omnidirectional
Tilt reading angle	-20 - 20 °
Pitch reading angle	-55 - 55 °
Operating time	240 min
Dimensions (WxDxH)	114 x 69 x 210 mm
Bluetooth	No
Operating frequency	910 MHz
Input voltage	10 - 30 V
Battery capacity	2150 mAh
Power requirements	0.33 - 1A
Number of reads per charge	60000
Certification	IP64, China RoHS, EU RoHS, CDRH Class II, IEC 60825-1 Class 2
Keys quantity	3 keys
Product color	Black, Yellow
LED indicators	Charging, Power
Display resolution	32 x 96 pixels
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 90 %

Weight and Dimensions

Weight	393 g