Datasat AP20 - Page 46

AP20 Installation and Operating Guide Page 46
AP20 Installation & Operating Guide Document # 9301H39200 Ver. 1.25
3.1 Example: Creating a Format
Prior to creating a format, it is necessary to identify the following:
 Input source
 Format option
 EQ set up
 Output channel profile name
The following example describes how to create “non-sync 2” format, with stereo input, global delay of 0
ms, assignment of EQ and audio profile.
1. Open the Audio Format Setup screen.
Menu (System) > Formats
2. Next select Edit Formats. The Audio Format Edit screen displays.
3. On the left side choose the Copy Format radio button.
4. Under Copy Format From select Nonsync.
5. Touch the blank box under to Format. A keyboard will appear.
Type in Nonsync 2, then select OK. The Audio Format Edit screen will return.
6. Touch the Copy button.
The screen will now change to Audio Format Setup.
7. Select Assign Buttons and the Format Button Assignments screen will display. Select an
unused button number from the Buttons drop down menu. In this example select button 3.
8. Next from the Assign drop down list, select Nonsync 2. Then touch the Assign button on the
right side of the screen. In the Current Assignments listing on the screen, Button 3 will now be
assigned to Nonsync 2.
9. At the bottom of the screen, touch the Formats button to return to the Audio Format Setup
screen.
10. Select the Input Source button. This will open the Input Select screen.
The right side of the screen should display “Current Format: Nonsync2”.
If it is not displayed, return to the Audio Format Setup screen by selecting the Format button
and selecting Nonsync 2 in the Current Audio Format drop down menu. Return to the Input
Select screen by touching the Input Source button.
11. In the Analog input section, touch the NonSync1 L/R option to change it to NonSync2 L/R.
Then touch the Formats button to return to the Audio Format Setup screen.
12. In the Audio Format Setup screen, select the Format Options button to go to the Format
Options screen.
13. In the Format Options screen, you can (if necessary) set the Global Delay for the selected
format.
Select the Nonsync Level and Routing button to change input gain and routing of the Nonsync
signal.
Touch the Formats button to return to the Audio Format Setup screen.