Datasat AP20 - Page 80

AP20 Installation and Operating Guide Page 80
AP20 Installation & Operating Guide Document # 9301H39200 Ver. 1.25
4.3.7.2 Edit EQs
Selecting the Edit EQs button from the Audio EQ Setup screen will open the screen below.
Menu (System) > Formats > Audio EQ > Edit EQs
Figure 55. Audio EQ Edit Screen
Available options are:
 Copy EQ – Use an existing EQ setup as a template for a new one. Select the EQ you wish to
copy from by selecting it from the drop down box. Then, touch the “to EQ” box to bring up
the virtual keyboard and enter a name for the new EQ. Press the Copy button to complete the
process, or press Cancel to quit.
 Copy Preset to EQ – Select a preset EQ setup and use it as a template for a new one. Press
the Copy button to complete the process, or press Cancel to quit.
 Rename EQ – Give an existing EQ setup a new name. Select an existing EQ setup from the
drop-down list on the right side of the screen. Touch the “To” box to bring up the virtual
keyboard and enter a new name for the EQ setup. Press the Rename button to complete the
process, or press Cancel to quit.
Note: The EQ name is changed for all formats that use the EQ.
 Delete EQ – Select an existing EQ setup from the drop-down list on the right side of the
screen. Press the Delete button to complete the process, or press Cancel to quit.
4.3.7.3 Dirac Optimization
The Dirac Li
ve setup procedure must be used to copy Dirac configuration setup files to the AP20
before this screen becomes functional. Ignore this screen if you are not using Dirac Live
software to setup the AP20.