2. Transducer Connections ........................................................................... 10A16-4C.2
3. Setup and/or Operating Considerations
a. Setting a 10A16-4C Channel for Four-Wire or
Three-Wire RTD Cabling ...................................................................... 10A16-4C.4
b. Configuration and Calibration ............................................................ 10A16-4C.4
c. High RTD Resolution with Specially Modified 10A16-4C ......... 10A16-4C.5
•
Model 10A17-2 Dual High-Voltage Isolation RTD Conditioner Card
1. General Description and Specifications ............................................... 10A17-4C.1
2. Transducer Connections ........................................................................... 10A17-4C.2
3. Setup and/or Operating Considerations
a. Configuration and Calibration ............................................................ 10A17-4C.3
b. High RTD Resolution with Specially Modified 10A17-2 ............ 10A17-4C.3
•
Model 10A18-4C Quad 100-Ohm Platinum Linear RTD Conditioner Card
1. General Description and Specifications ............................................... 10A18-4C.1
2. Transducer Connections ........................................................................... 10A18-4C.3
3. Setup and/or Operating Considerations
a. Setting a 10A18-4C Channel for Four-Wire or
Three-Wire RTD Cabling ...................................................................... 10A18-4C.5
b. Configuration and Calibration ............................................................ 10A18-4C.5
Calculated Calibration ........................................................................... 10A18-4C.5
Two-Point (Deadweight) Calibration ................................................ 10A18-4C.7
•
Model 10A30-2C Dual LVDT Conditioner Card
1. General Description and Specifications ............................................... 10A30-2C.1
2. Transducer Connections ........................................................................... 10A30-2C.2
3. Setup and/or Operating Considerations
a. Configuration and Calibration ............................................................ 10A30-2C.6
•
Model 10A31-4 Quad LVDT Conditioner Card
1. General Description and Specifications .................................................. 10A31-4.1
2. Transducer Connections .............................................................................. 10A31-4.2
3. Setup and/or Operating Considerations
a. Configuration and Calibration ............................................................... 10A31-4.8
•
Model 10A35 Encoder Conditioner Card
1. General Description and Specifications ...................................................... 10A35.1
2. Transducer Connections .................................................................................. 10A35.1
3. Setup and/or Operating Considerations
a. Configuration and Operation
Count Predivision ........................................................................................... 10A35.3
Zero-Indexing (Resetting) the 10A35 ..................................................... 10A35.3
Returning the 10A35 to “RUN MODE” .................................................... 10A35.3
•
Model 10A40 Frequency Input Conditioner Card
1. General Description and Specifications ...................................................... 10A40.1
2. Transducer Connections
a. Standard Cabling ........................................................................................... 10A40.2
b. Special Cabling
Ungrounded Frequency Source .............................................................. 10A40.4
Elimination of DC Offset .............................................................................. 10A40.4
Suppression of High-Frequency Noise in
Low-Frequency Input ................................................................................ 10A40.4
c. Pull-Up Resistor .............................................................................................. 10A40.5
vii
C
ONTENTS
To Next Page
Loading...