DSE Model 5310 Automatic Mains Failure & Instrumentation System Operators Manual
Part No. 057-013 5310 OPERATING MANUAL ISSUE 7.1 18/06/2007 ADM 25
5.2.3 MODEM STATUS
When configured and connected to a GSM Modem for cellular network communications, the GSM MODEM
STATUS screen shows the following information.
Modem Status
The modem is reset by the 5300 series controller.
Resetting modem
Modem Status
Modem initialising strings are sent to the modem (as set in the Edit Config | Comms
tab of the configuration software.
Initialising modem…
Modem Status
The modem has been initialised and is ready to answer.
Ready to answer
If the module does not detect that the modem is operating correctly, this procedure begins again from Resetting
modem and will continue to repeat until the modem operation is detected correctly.
GSM STATUS
If the DSE controller detects that the modem connected is a GSM modem, the following additional status is shown:
Modem Status
The modem has been initialised and is ready to answer. OK shows the SIM card is
inserted but there is no signal
Ready to answer
OK
Modem Status
The modem has been initialised and is ready to answer.
The SIM card is inserted, the signal is received full strength and the operator name is
shown.
NOTE:- Operator name is not available in all GSM areas.
Ready to answer
OK
ORANGE UK
Modem Status
The modem has been initialised and is ready to answer.
The SIM card is inserted, the signal is received but is low and the operator name is
shown.
NOTE:- Operator name is not available in all GSM areas.
Ready to answer
OK
ORANGE UK
To Next Page
Loading...
Need help?
General
