DSE Model 5310 Automatic Mains Failure & Instrumentation System Operators Manual
Part No. 057-013 5310 OPERATING MANUAL ISSUE 7.1 18/06/2007 ADM 33
6.2.3 EDITING THE CURRENT DATE AND TIME
The date and time can be set either using the 5xxx series configuration software or the front panel configuration
editer.
NOTE:- The 5320 controller maintains the current date and time so long as it is connected to a DC
supply within the operating range. Disconnection of the supply will result in the date and time being
frozen until the module’s power is reapplied. When this occurs, the date and time will resume operation
from the time the power was disconnected. If this occurs you can use the front panel configuration
editor to correct the date and time or reset it using the 5xxx series configuration software.
NOTE:- The calendar is used by the 5310’s run scheduler and the event log.
Date and time
Press the Stop/Reset and Info
i
buttons simultaneously.
If the module PIN number has been set, the PIN number request
is then shown. The configuration cannot be viewed or changed
until the PIN number is correctly entered. (see the section
ACCESSING THE FRONT PANEL CONFIGURATION EDITOR)
Press the + button until the desired page is shown. Date and
time
19 Sep 2005 10:00
Date and time
To edit the Date and time, press the 9 button, the minutes will
start to flash. Pressing the
+ or – buttons will adjust the
minutes to the desired value.
19 Sep 2005 10:00
Date and time
Press the button to ‘save’ the value, and select the hours
for adjustment. The hours will start to flash.
Pressing the
+ or – buttons will adjust the hours to the desired
value.
19 Sep 2005 10:00
Date and time
Press the button to ‘save’ the value, and select the day for
adjustment. The day will start to flash.
Pressing the
+ or – buttons will adjust the day to the desired
value.
19 Sep 2005 10:00
To Next Page
Loading...
Need help?
General
