SENTINEL 3 15
Important notes before operation
1. To power off the DVR, make sure the DVR is not recording to prevent le corruption.
If on manual record, press STOP to stop recording and wait for the REC light to turn
off before you power off the DVR. If in schedule record, press MENU and enter the
password to enter the menu screen. When the record light turns off, you can power
off the DVR.
2. The default password is 11111111.
3. This DVR does not support HDD hot swap. To prevent damage, please enter the
main menu to stop all HDD activities, then power-off the device before replacing the
hard disk.
4. After power-on, the DVR auto detects the video system (NTSC/PAL) of the rst
camera connected. When no camera has been connected, the video system will be
the same as the previous setup.
5. After power-on the system auto enters 9-split screen mode, and continues with the
previously setup recording schedule (auto resume recording)
4. MONITOR OPERATION
4.1 BASIC OPERATION
1. Manual Switching Video Inputs: Press the AV button on the remote to switch between
video inputs.
2. Press the AUTO button on the monitor to activate auto mode, which will automatically
cycle between both inputs. Pressing it once will set the cycle interval to 4 seconds.
Pressing it again will set the cycle interval to 6 seconds. Pressing it a third time will
set the cycle interval to 8 seconds. Pressing it a fourth time will turn off auto mode
4.2 ADJUSTING SETTINGS
Press the menu button to display the following options:
PICTURE, OPTION, CLOCK, SYSTEM
4.2.1 PICTURE
1. Press the menu button once to display the PICTURE menu.
2. In this menu you can adjust Contrast, Brightness, Color, and Sharpness
3. Use the channel up and down buttons to select the desired setting, and use the
volume buttons to increase or decrease the values.
4. Press the MENU key to exit the PICTURE menu.
4.2.2 OPTION
1. Press the menu button twice to display the OPTION menu.
2. In this menu you can adjust Language, Calendar, and Auto Change Source
3. To change the language, select it and use the volume keys to scroll through the
available languages.
To Next Page
Loading...
Need help?
General
