1.3 About the User manual
1.3.1 General purpose
This document includes important instructions that should be followed during installation and maintenance of the controller.
Only approved personnel can do the installation and maintenance work. The work must comply with all applicable state and
local electrical codes. Efficient and safe operation of the controller is only possible if equipment operation and configuration
is correct, and maintenance is completed.
1.3.2
Software versions
The information in this document relates to software versions:
Software
Versions
Application software 9.04
1.4 Warnings and safety
1.4.1 Symbols for hazard statements
WARNING
This shows potentially dangerous situations.
If the guidelines are not followed, these situations could result in death, serious personal injury, and equipment
damage or destruction.
CAUTION
This shows low level risk situation.
If the guidelines are not followed, these situations could result in minor or moderate injury.
1.4.2 Symbols for general notes
NOTE This shows general information.
More information
This shows where you can find more information.
1.4.3 Electrical safety
You must ground the generator before you install the controller or do maintenance work. Failure to ground the generator
can result in injury or death.
Generators produce high electrical voltages. Do not touch terminals, bare wires, and while the generator and related
equipment are in operation. If you touch the generator, it can give you an electrical shock and result in death. Do not change
the interlocks.
Use the correct size for wires that are used for electrical connections and wirings. This is to make sure that the generator
can operate at the maximum electrical current.
User manual 4189341340A EN
Page 6 of 76
To Next Page
Loading...
