Deif SGC 120 - Configurable Parameters; 3.5.1 Module Parameters

5. Enter the password:
a. Use the Up
and Down buttons to change the number.
b. Select a number with the Start button.
6. You can now configure the parameter.
7. To leave the configuration menu, push and hold the Stop/Config
button.
8. Until the configuration is saved, you will see this screen:
3.5 Configurable parameters
3.5.1 Module
General (GENERAL)
Parameter
Range Default Description
Profile name Profile 1 Profile 1 You can change the name of the profile.
Power on Mode
 ON 
Manual
Auto
-
The controller is in this running mode when you
power on the controller.
Power On Lamp Test
 ON LAMP

Enable
Disable
Not enabled
If this parameter is enabled, the LEDs glow red
for 2 seconds after a power reset.
Deep Sleep Mode
 SLEEP 
Enable
Disable
Not enabled
If this parameter is enabled, the controller goes
into deep sleep mode when the controller is not
in use for an adjustable time.
Auto-Clear Warning
Alarm
 CLEAR

Enable
Disable
Not enabled
If this parameter is enabled, the controller
automatically clears an active alarm, when you
have resolved the condition that activated the
alarm.
Language


English
Chinese
English
You can change the display language if the
controller supports multiple languages.
Display (DISPLAY)
Parameter
Range Default Description
Contrast

0 to 100 % 80 %
Configure the display contrast with this
parameter.
Power Save Mode
 SAVE 
Enable
Disable
Not enabled
If this parameter is enabled, the controller turns
off the LCD backlight after an adjustable time.
This is only when the engine is not in operation.
You can configure the adjustable timer with the
smart connect software in Timers > General
> Power Save Mode Delay
User manual 4189341340A EN Page 20 of 76