8. CAN bus engine communication
8.1 Overview
8.1.1 About
Engine communication allows the SGC controller communicate with different engine types over CAN bus. Some engine
types only allow the SGC to read information from the ECU. Other engine types allow the controller to regulate and transmit
commands to the ECU.
NOTE See the ECU user manuals for the ECU protocol technical description and details of each communication value.
Other engines and controllers
For engines and controllers not listed in this document, contact DEIF.
8.1.2
Default settings
The SGC controller is delivered with a set of default settings for engine communication. These settings are not necessarily
correct for your engine or genset. Check all the settings before you operate the engine or genset.
8.1.3
Supported engines
The SGC controller can communicate with these engines:
Manufacturer
SGC can write commands
Cummins Yes
Cummins 500 Yes
Cummins 558 Yes
Cummins 570 Yes
Cummins 850 Yes
Cummins 2150 Yes
Cummins 2250 Yes
DCEC Cummins Yes
Deutz - EMR Yes
Generic J1939 Yes
Hatz Yes
Iveco Yes
KUBOTA Yes
MTU Yes
Perkins ADEM4 Yes
Scania Yes
Volvo Penta Yes
Weichai Yes
Yuchai BOSCH Yes
Yuchai YCHCU ECU Yes
User manual 4189341340A EN Page 67 of 76
To Next Page
Loading...
