2. Installation
2.1 Dimensions
Length Height Depth
Controller 139.0 mm in) 114.0 mm in) 38.3 mm in)
Panel cut-out 118.0 mm in) 93.0 mm in)
Tolerance: ± 0.3 mm
in)
2.2 Tools and materials
Tools required for mounting
Tool
Used for
Safety equipment
Personal protection, according to local standards and
requirements
Screwdriver, PH2 or 5 mm flat Tighten the fixing screw clamps, torque 0.15 N·m lb-in)
Wire stripper, pliers and cutters Prepare wiring and trim cable ties
NOTICE
Too much torque damages the screw clamps and/or controller housing
Do not use power tools during the installation.
User manual 4189341340A EN Page 8 of 76
To Next Page
Loading...
