Parameter Range Default Description
level is less than the warning set point
Threshold).
Warning Threshold 0.2 to 10.0 Bar 3 Bar
If the lube oil pressure is more than this set
point, the controller activates a warning alarm.
3.5.9 Maintenance
Maintenance (MAINT ALARM)
Parameter
Range Default Description
Alarm Action
None
Notification
Warning
Notification Configure the alarm action for maintenance.
Due At Engine Hours
AT ENGINE
10 to 65000 hours 250 hours
The maintenance timer is based on running
hours.
Alarm Due Date
DUE
dd/mm/yyyy - An alarm occurs when it is the due date.
3.5.10 Password ID
ID
Parameter
Input Range Description
#### Numbers: 0 to 9 The password for level 1 access.
#### Numbers: 0 to 9 The password for level 2 access.
3.6 Password
The controller has two password levels that you can configure on the controller. Parameter settings cannot be changed with
a lower ranking password, but are shown on the display.
Password level
Access Factory setting
1 Full access (read and write) 0123
2 Limited access (read) 1234
Change the password on the controller:
1. Go to Configuration menu.
2. Log on with the password for level 1.
3. Use the Up
and Down buttons to go to Misc Settings. Push the Start button to select.
4. Use the Up and Down buttons to go to the password you want to change. Select the password with the Start
button.
5. Use the Up and Down buttons to select the first digit in the new password. Confirm your selection with the Start
button.
6. Do step 5 again for the three remaining digits.
7. When you have selected all four digits, you will see this display:
User manual 4189341340A EN
Page 39 of 76
To Next Page
Loading...
