Materials required for mounting and wiring
Materials Used for
Four screw clamps Mounting the controller in the front panel
Wires and connectors Wiring third party equipment to the controller terminals
Cable ties Securing wiring
2.3 Mounting
The controller is designed for mounting in the front panel.
Panel cutout:
• Length: 118.0 mm
• Height: 93.0 mm
• Tolerance: ± 0.3 mm
1. Insert the controller in the panel.
2. Insert the screw clamps:
*Click*
3.b.1 3.b.4
3.b.2
3.b.3
3. Tighten the screw clamps to 0.19 Nm. Do not tighten the clamps to more than 0.19 Nm.
2.4 Terminals
User manual 4189341340A EN Page 9 of 76
To Next Page
Loading...
