78
Cod.: 240.010.0042
DLS / DLS-C Series
1. "MPPT CONF." - The page allows to set the INDEPENDENT or PARALLEL operating mode based
on the type of system. The default factory is INDEPENDENT mode.
PARAMETER VALUE DESCRIPTION
MPPT Conf. Indip./Parall. PV string inputs conguration selection (Default = INDEPENDENT)
2. "V AC NOM" - The page allows to set the nominal grid phase voltage.
3. "F AC NOM" - The page allows to set the nominal grid frequency.
4. "IFV1 TAR" - The page allows to calibrate the current reading of the photovoltaic string connected to
the PV1 input.
5. "IFV2 TAR" - The page allows to calibrate the current reading of the photovoltaic string connected to
the PV2 input.
6. "CAN ADDR." - The page allows to perform MASTER / SLAVE settings in the case of systems con-
sisting of several units in parallel according to the following table:
PARAMETER VALUE DESCRIPTION
CAN Addr.
0 Single unit (default)
1 MASTER unit
2 - 3 SLAVE unit
7. "EPS" - The page allows to enable / disable the EPS functionality.
PARAMETER VALUE DESCRIPTION
EPS ON/OFF AC OUT port operation enable (Default = OFF)
8. "ENERGY METER SETUP" - The page allows to select the type, brand and model of any external
energy meter connected to the AC distribution network among those supported by the DLS system. The
selection of one of the en-ergy meters indicated congures the DLS system to interact exclusively with
the type, brand and model of energy meter selected. The settings are accessible only in the INSTALLER
mode which re-quire a password to be logged in (see the "LOGIN menu" section). WARNING - The
type, brand and model of the approved and listed energy meters may be subject to change at
any time and without notice.
PARAMETER VALUE DESCRIPTION
Energy Meter Setup
No meter Internal energy meter enabled (Default)
ET112 Carlo Gavazzi ET112 external energy meter enabled
ET340 / EM540 Carlo Gavazzi ET340 / EM540 external energy meter enabled
EM210 Carlo Gavazzi EM210 external energy meter enabled
9. "PV METER SETUP" - The page allows you to congure the functionality of a possible auxiliary energy
meter connected to the production line of an existing ON-GRID inverter to collect its production data to
be combined with a DLS inverter coupled on AC network. The selection of one of the energy meters
indicated cong-ures the DLS system to interact exclusively with the type, brand and model of energy
meter selected. The settings are accessible only in the INSTALLER mode which require a password
to be logged in (see the "LOGIN menu" section).
To Next Page
Loading...