What to do if my Delios DLS 300 shows Faulty protection interface device integrated in the system?
If your Delios Inverter indicates a faulty protection interface device, switch off and restart the system. Refer to the sections "System switching off" and "System switching on". Should the problem persist, contact our technical support service.
What to do if my Delios DLS 300 Inverter shows Faulty interlock device integrated in the system?
If your Delios Inverter indicates a faulty interlock device, switch off and restart the system. Refer to the sections "System switching off" and "System switching on". Should the problem persist, contact our technical support service.
What to do if my Delios DLS 300 shows Failed AUTOTEST (relevant only for CEI 0-21)?
If your Delios Inverter failed AUTOTEST (relevant only for CEI 0-21), check the integrity of the electrical connections. Make sure that the mains voltage and frequency are within the range allowed by the CEI 0-21 standard. If the problem persists, contact the technical support service.
What to do if my Delios DLS 300 Inverter shows Converter control system fault?
If your Delios Inverter is showing a converter control system fault, switch off and restart the system. Refer to the sections "System switching off" and "System switching on". Should the problem persist, contact our technical support service.
What to do if my Delios DLS 300 shows Loss of isolation of the PV generator?
If your Delios Inverter indicates a loss of isolation of the PV generator, check the DC lines leakage to ground.
General| Input Voltage | 12V DC |
|---|---|
| Continuous Power | 300W |
| Surge/Peak Power | 600W |
| Output Waveform | Modified Sine Wave |
| USB Output | 5V DC, 2.1A |
| Efficiency | Up to 90% |
| Frequency | 50Hz |
| Protection Features | Overload, Overheat, Short Circuit |
| Cooling | Fan Cooling |
| USB Port | 1 x USB Type-A |
To Next Page