S5200F-ON Series switch installation
To install the S5200F-ON Series (S5232F-ON, S5248F-ON, S5296F-ON, S5224F-ON, and S5212F-ON) switch, complete the installation
procedures in the order presented in this chapter.
Always handle the switch and components with care. Avoid dropping the switch or its eld replaceable units (FRUs).
For the S5212F-ON switch installation instructions, see One-half U front-rack installation. For the S5224F-ON, S5248F-ON, and S5232F-
ON switches, you can install the ReadyRails system. Due to the chassis weight, the S5296F-ON switch does not support a two-post rack
installation; you must install the S5296F-ON in a four-post rack. For the S5296F-ON switch installation instructions, see S5296F-ON four-
post rack assembly.
NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when
handling the S5200F-ON Series switch and components. As with all electrical devices of this type, take all the necessary safety
precautions to prevent injury when installing this switch.
Topics:
• Unpack
• Ground cable
• Rack or cabinet hardware installation
• One-half U front-rack installation
• One U ReadyRails installation
• Two U four-post rack assembly
• DC power connections
• S5212F-ON only DC power connections
• Optics installation
• Switch start up
• After switch placement
• Switch replacement
Unpack
NOTE
: Before unpacking the switch, inspect the container and immediately report any evidence of damage.
NOTE: For the S5212F-ON and S5296F-ON switches only: the USB extension cable is packaged separately. Do not throw it
away.
When unpacking the switch, make sure that the following items are included:
• One S5200F-ON Series switch
• Two sets of rail kits, no tools needed
• One RJ45 to DB-9 female cable
• S5232F-ON, S5248F-ON, S5296F-ON, and S5224F-ON: Ground lug kit
• S5232F-ON, S5248F-ON, S5296F-ON, and S5224F-ON: Two hot-swappable PSUs
• S5232F-ON, S5248F-ON, S5296F-ON, and S5224F-ON: Four hot-swappable fan units
• S5212F-ON: Two xed PSUs
4
30 S5200F-ON Series switch installation
To Next Page
Loading...
