After switch placement
After you have securely installed and powered on the S5200F-ON Series switch:
• For switch documentation and resources, see the Dell EMC Networking Hardware Platforms and OS9 Info Hub.
• For OS10 Networking operating system documentation and resources, see the Dell EMC Networking OS10 Info Hub.
• For ONIE documentation and resources, see ONIE information at www.onie.org.
Switch replacement
The following steps describe removing and replacing a switch with an identical replacement switch. For further assistance when replacing a
switch, contact your Dell EMC support representative.
NOTE: Some steps do not apply if you are replacing a dierent switch or non-Dell EMC switch.
NOTE: ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the switch and accessories. After you remove the original packaging, place the switch and components on an
anti-static surface.
1 Back up the switch conguration to your back-up computer or laptop TFTP server.
copy running-config tftp://hostip/filepath
2 Disconnect the power source.
3 Label and remove all cables.
4 Remove the switch from the rack.
At the same time, press in the two side-release bars on the switch and slide the switch forward.
If you are using the fan trays or PSUs in the replacement switch, remove them from the switch.
5 Unpack the new switch.
For more information, see Unpack.
6 Install the new switch in your rack or cabinet.
For detailed installation instructions, see S5200F-ON Series switch installation.
If you are using the fan trays or PSUs from the removed switch, reinsert them in the replacement switch.
7 Power on the switch.
For more information, see Switch power up.
8 Establish a connection to the switch CLI.
9 Conrm that the software version of the replacement switch is the same as the previously installed switch.
show os-version
If the software versions do not match, upgrade the replacement switch software using the procedure included with the rmware
download.
10 Copy the backed-up switch conguration to the new switch.
copy tftp://hostip/filepath running-config
11 Connect all the cables.
S5200F-ON Series switch installation
47
To Next Page
Loading...
