One-half U switch installation
Install one or two half-U switches in the four-post rack-mounted dual tray.
1 Install one switch into either dual-tray slot from the front.
2 Insert the second switch in the open dual-tray slot if you are installing two switches.
The switch is fully inserted when it presses the stop features on the dual tray. The front switch latch snaps the switch into place.
Close-up view of the stop at the back of the switch.
One-half U switch removal
Remove the S5212F-ON switch using the following instructions:
NOTE
: To remove the S5232F-ON, S5248F-ON, S5296F-ON, or S5224F-ON switch, see One U ReadyRails installation. To
remove the S5296F-ON switch, see Two U four-post rack assembly.
Push in the front switch latches according to the latch arrows and pull out the switch.
34
S5200F-ON Series switch installation
To Next Page
Loading...
