EasyManua.ls Logo

Dell EMC PowerSwitch S4100-ON Series - European Union EMC Directive Conformance Statement; Japan VCCI Compliance for Class a Equipment

Dell EMC PowerSwitch S4100-ON Series
205 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
European Union EMC directive conformance
statement
This product is in conformity with the protection requirements of EU Council Directive 2004/30/EC on the approximation of the laws of
the Member States relating to electromagnetic compatibility. Dell EMC cannot accept responsibility for any failure to satisfy the protection
requirements resulting from a non-recommended modication of this product, including the tting of non-Dell EMC option cards.
This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 32/
CISPR34 and EN55032 / EN55034. The limits for Class A equipment were derived for commercial and industrial environments to provide
reasonable protection against interference with licensed communication equipment.
WARNING: This is a Class A product. In a domestic environment, this device may cause radio interference, in which case, you
may be required to take adequate measures.
European Community Contact
Dell EMC, EMEA - Central
Dahlienweg 19
66265 Heusweiler
Germany
Tel: +49 172 6802630
Email: EMEA Central Sales
Japan VCCI compliance for class A equipment
Figure 30. Japan: VCCI compliance for class A equipment
This is Class A product based on the standard of the Voluntary Control Council For Interference by Information Technology Equipment
(VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be
required to take corrective actions.
WARNING
: Use the AC power cords with Dell EMC equipment only. Do not use Dell EMC AC power cords with any unauthorized
hardware.
Specications 49

Table of Contents

Related product manuals