1 DC wire RTN 2 DC power connector
3 Captive screws (2) 4 Orange tab
5 PSU status LED 6 DC power socket
7 DC wire -48V
The DC power connector ground:
1
Ground nut 2 Washer
3 Lock washer 4 Ground cable
5 Device grounding rod
To connect a DC PSU to the site’s DC power source:
1 Strip 1/2 inches of insulation from each of the power connector’s wires, as shown.
2 Insert each of the power connector’s bare wire lengths into the wiring block, as shown.
3 Use a at-blade screwdriver to tighten the screws that secures the bare wires into the wiring block.
4 Secure the site’s DC power source wires to the other side of the wiring block (See steps 1 and 3).
44
S5200F-ON Series switch installation
To Next Page
Loading...
