64 Installing Optional Accessories
7
Press button until
Start
appears, and then press the
(Set)
button.
8
Ensure that the message
Please wait Wireless Setting
is
displayed, and start the WPS-PBC on the wireless LAN access point
(Registrar), within two minutes of the step 7 operation.
NOTE: For WPS operation on the wireless LAN access point, refer to the
manual supplied with the wireless LAN access point.
9
When the WPS operation is successful and the printer is rebooted, wireless
LAN connection setting is completed.
Operator Panel
1
Press the
(Menu)
button.
2
Press button until
Admin Menu
appears, and then press the
(Set)
button.
3
Press button until
Network
appears, and then press the
(Set)
button.
4
Press button until
Wireless Setup
appears, and then press the
(Set)
button.
5
Ensure that
Manual Setup
is displayed, and then press the
(Set)
button.
6
Enter the SSID, and then press the
(Set)
button.
7
Select the network mode from
Infrastructure
and
Ad-hoc
depending on your environment.
When you select
Infrastructure
, proceed to step 8.
When you select
Ad-hoc
, proceed to step 9.
8
Select the encryption type from
No Security
,
WEP (64Bit)
, and
WEP
(128Bit)
.
When you do not set security for your wireless network:
a
Ensure that
No Security
is displayed, and then press the
(Set)
button.
To use 64 bit or 128 bit WEP encryption:
a
Press button until
WEP (64Bit)
or
WEP (128Bit)
appears,
and then press the
(Set)
button.
b
Enter the WEP key, and then press the
(Set)
button.
To Next Page
Loading...
