Understanding the Printer Menus 293
Network
Use the Network menu to change the printer settings affecting jobs sent to the
printer through the wired or wireless network.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The
change becomes effective after the printer is turned off and then on again.
Values:
Wireless Status
NOTE: Wireless Status feature is available only when the printer is connected
using the wireless network.
Purpose:
To confirm the wireless communication status.
Values:
Color Prints in the color mode.
Auto
*
Detects the Ethernet settings automatically.
10BASE-T Half Uses 10BASE-T Half-duplex.
10BASE-T Full Uses 10BASE-T Full-duplex.
100BASE-TX Half Uses 100BASE-TX Half-duplex.
100BASE-TX Full Uses 100BASE-TX Full-duplex.
1000BASE-T Full Uses 1000BASE-T Full-duplex.
Connection Good
Acceptable
Low
No Reception
To Next Page
Loading...
