Right Lighting-Board
3
Replace the screws that secure the right lighting-board to the right-side
middle panel.
4
Connect the right lighting-board cable to the connector on the master I/O
board.
Postrequisites
1
Replace the right-side top panel. See "Replacing the Right-Side Top Panel"
on page 110.
2
Replace the drive-bay shroud. See "Replacing the Drive-Bay Shroud" on
page 48.
3
Close the PCI shroud. See "Closing the PCI Shroud" on page 46.
4
Replace the left side-panel. See "Replacing the Left Side-Panel" on
page 27.
5
Follow the steps in "After Working Inside Your Computer" on page 15.
book.book Page 119 Wednesday, May 16, 2012 2:37 PM
To Next Page
Loading...
