Steps
1 Remove the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
2 Lift the power-adapter port bracket o the palm-rest assembly.
3 Lift the power-adapter port along with its cable o the palm-rest assembly.
Installing the power-adapter port
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation
procedure.
Steps
1 Place the power-adapter port into the slot on the palm-rest assembly.
2 Place the power-adapter port bracket on the power-adapter port.
3 Replace the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
Next steps
1 Install the system board.
2 Install the right I/O-board.
3 Install the battery.
4 Install the rear I/O-cover.
5 Install the 2230 solid-state drive. (if applicable)
6 Install the 2280 solid-state drive. (if applicable)
7 Install the base cover.
8 Follow the procedure in After working inside your computer.
51
To Next Page
Loading...
