Audio Tone
Purpose:
To configure settings for tones emitted by the printer during operation or when a warning message appears.
Va lu e s:
Control Panel Off
*
Does not emit a tone when the operator panel input is correct.
On Emits a tone when the operator panel input is correct.
Invalid Key Off
*
Does not emit a tone when the operator panel input is incorrect.
On Emits a tone when the operator panel input is incorrect.
Machine Ready Off Does not emit a tone when the printer is ready to process a job.
On
*
Emits a tone when the printer is ready to process a job.
Job Completed Off Does not emit a tone when a job is complete.
On
*
Emits a tone when a job is complete.
Fault Tone Off Does not emit a tone when a job ends abnormally.
On
*
Emits a tone when a job ends abnormally.
Alert Tone Off Does not emit a tone when a problem occurs.
On
*
Emits a tone when a problem occurs.
Out of Paper Off Does not emit a tone when the printer runs out of paper.
On
*
Emits a tone when the printer runs out of paper.
Low Toner Alert Off Does not emit a tone when a toner is low.
On
*
Emits a tone when a toner is low.
Auto Clear Alert Off
*
Does not emit a tone 5 seconds before the printer performs auto clear.
On Emits a tone 5 seconds before the printer performs auto clear.
All Tones Off
*
Disables all the alert tones.
On Enables all the alert tones at once.
mm / inch
Purpose:
To specify the default measurement unit displayed after the numeric value on the operator panel.
Va lu e s:
Millimeters (mm)
*
Selects millimeter as the default measurement unit.
Inches (") Selects inch as the default measurement unit.
NOTE: The default for mm/inch varies depending on other settings, such as Country and Document Size.
Default Paper Size
Purpose:
To specify the default paper size.
Va lu e s:
mm series
A4
*1
Letter
Understanding the Printer Menus
180
To Next Page
Loading...
