EX300 network cabling
The network cabling diagrams apply to the EX300 appliance in a Dell EMC or customer-provided rack.
Customers connect to an EX300 appliance by way of 25 GbE ports on the front-end switches. For an EX300 appliance, the 25
GbE ports run at 10 GbE. Customer configurations can include 25 GbE front-end switches provided by Dell EMC or customers
may provide their own front-end switches.
To distinguish between the two front-end switches and the two back-end switches, each switch has a nickname:
● Hare: The top S5148F 1U 25 GbE front-end switch. This switch runs 10 GbE SFP28 ports to EX300 nodes. It is located above
the Rabbit switch in U22 of the EX300 rack.
● Rabbit: The bottom S5148F 1U 25 GbE front-end switch. This switch runs 10 GbE SFP28 ports to EX300 nodes. It is located
below the Hare switch in U20 of the EX300 rack.
● Hound: The top S5148F 1U 25 GbE back-end switch running 10 GbE SFP28 ports to the nodes. It is located above the Fox
switch in U18 of the EX300 rack.
● Fox: The bottom S5148F 1U 25 GbE back-end switch running 10 GbE SFP28 ports to the nodes. It is located below the
Hound switch in U16 of the EX300 rack.
112 EX300 Platform
To Next Page
Loading...
Need help?
General
