Table 26. Console Redirection COM1 (continued)
Parameter Settings Description
Flow Control None, Hardware RTS/CTS Flow control can prevent data loss from buffer overflow.
When sending data, if the receiving buffers are full, a stop
signal can be sent to stop the data flow. Once the buffers are
empty, a start signal can be sent to restart the flow. Hardware
flow control uses two wires to send start/stop.
VT-UTF8 Combo Key Support Disabled, Enabled Enable VT-UTF8 Combination Key Support for ANSI/VT100
terminals.
Recorder Mode Disabled, Enabled With this mode enabled, only text is sent. This is to capture
terminal data.
Resolution 100x31 Disabled, Enabled Enables or disables extended terminal resolution.
Putty KeyPad VT100, LINUX, XTERMR6,
SCO, ESCN, VT400
Select FunctionKey and KeyPad on Putty.
Figure 34. Console Redirection COM(Pci Bus0,Dev22,Func3)
Table 27. Console Redirection COM(Pci Bus0,Dev22,Func3)
Parameter Settings Description
Terminal Type VT100, VT100+, VT-UTF8,
ANSI
Emulation: ANSI: Extended ASCII character set. VT100: ASCII
character set. VT100+: Extends VT100 to support color,
BIOS Setup 39
To Next Page
Loading...
Need help?
General
