Dell EMC XC Core XC650 - Installing the Serial COM Port

Figure 96. Installing the filler bracket
Next steps
1. Replace the serial COM port.
Installing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Lift the expansion card riser and disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. If installed, remove the filler bracket from the expansion card riser (Riser 3).
NOTE:
For more information about how to remove the filler bracket, see the Remove the expansion card from the
expansion card riser topic.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
106 Installing and removing system components