Dell EMC XC Core XC650 - Optional OCP Card; Removing the OCP Card

Figure 82. Installing the BOSS S2 card carrier
Next steps
1. Follow the procedure listed in After working inside your system.
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the expansion card riser.
Steps
1. Open the blue latch to unlock the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board and slide the
OCP card out of the slot on the system.
92
Installing and removing system components