Identifier GUID-98F27B1C-9F09-48EC-83D7-FC85C825E6A4
Status Released
Replacing the I/O board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-90BE0D63-C5F7-44E2-831D-84F72D876966
Status Released
Procedure
1 Align the screw holes on the I/O board with the screw holes on the middle
frame.
2 Replace the four screws (M3x5) that secure the I/O board to the middle frame.
3 Connect the I/O cable (RUSBC1), the I/O-board cable (LAUOC1), the display
converter cable (CONVERTER), and the display-panel cable (EDPCN1) to the
I/O board.
4 Route the I/O-board power cable (RPWRC1) and the power cable (SB-DCPWR)
through the routing guides on the I/O board.
5 Connect the I/O-board power cable (RPWRC1), the display cable (SB-DISPC),
the USB Type-C cable (SB-TYPEC1), and the power cable (SB-DCPWR) to the
I/O board.
Identifier GUID-04DFACAA-7548-4A84-A079-897E8D472E03
Status Released
Post-requisites
1 Replace the I/O bracket.
103
To Next Page
Loading...
