Identifier GUID-5B4BA881-7BC3-40C6-8E48-8B01E3134AE5
Status Released
Replacing the media-card reader
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-5AD24448-7899-480B-A992-9CA22F8AE710
Status Released
Procedure
1 Align the screw holes on the media-card reader to the screw holes on the side
I/O-board bracket.
2 Replace the two screws (M3x5) that secure the media-card reader to the side
I/O-board bracket.
3 Using the alignment post, place the side-I/O bracket on the middle frame.
4 Align the screw holes on the side I/O-board bracket to the screw holes on the
middle frame.
5 Replace the two screws (M3x5) that secure the side I/O-board bracket to the
middle frame.
6 Connect the side I/O-board cable (MB-SUSBC) to the side I/O-board.
7 Connect the media-card reader cable (SDRDC1) to the media-card reader.
Identifier GUID-5BE3AE14-06F3-4D93-8158-E706F91E6665
Status Released
Post-requisites
1 Replace the inner frame.
53
To Next Page
Loading...
