Identifier GUID-2EFE7E92-337F-4710-A2AB-08FF9D39DEFF
Status Released
Replacing the side I/O-board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-97B32948-FA94-4179-B78C-59C73C00409E
Status Released
Procedure
1 Slide the side I/O-board into the slots on the side I/O-board bracket.
2 Align the screw holes on the side I/O-board with the screw holes on the side
I/O-board bracket.
3 Replace the two screws (M3x5) that secure the side I/O-board to the side I/O-
board bracket.
Identifier GUID-E12874A0-3312-443D-9D5A-7BB5A10BD261
Status Released
Post-requisites
1 Follow the procedure from step 3 to step 7 in “Replacing the media-card reader”.
2 Replace the inner frame.
3 Replace the stand.
4 Replace the back cover.
57
To Next Page
Loading...
