Dell PowerConnect 55xx Systems User Guide 113
Configuring IPv6-based ACLs Using CLI Commands
The following table summarizes the CLI commands for configuring
I
Pv6-based ACLs.
The following is an example of some of the CLI commands:
IPv6-Based ACEs
To add a rule to an IPv6-based ACL:
1
Click
Switching
>
Network Security
>
IPv6 Based ACE
to display the
IPv6 ACE: Summary
page.
Figure 8-7. IPv6 Based ACE: Summary
Table 8-6. IP-Based ACL CLI Commands
CLI Command Description
ipv6 access-list [access-list-
name]
no ipv6 access-list [access-
list-name]
Defines an IPv6 access list and places
the device in IPv6 access list
configuration mode
Use the no form of this command to
remove the access list.
console(config)# ipv6 access-list server-acl
To Next Page
Loading...
