Dell PowerConnect 55xx Systems User Guide 55
Configuration Work Flow
To configure the switches:
1
For each switch in the stack:
a
Connect it to a terminal, as described in the "Connecting the Switch
to the Terminal" on page 56.
b
Boot the switch, as described in the "Booting the Switch" on page 57.
c
Assign a unit ID to the switch, as described in "Assigning Unit IDs" on
page 48.
2
Connect the units in the stack to each other, as described in "Configuring
the Stack" on page 58.
3
Connect the Master unit to the terminal, reboot the unit and the Setup
Wizard is run automatically, as described in "Configuration Using the
Setup Wizard" on page 58.
4
Respond to the Setup Wizard prompts.
5
Continue managing the switch, either through the console or Telnet, using
the CLI or the web GUI.
To Next Page
Loading...
