Dell POWERCONNECT 5524P - Global Settings

Dell PowerConnect 55xx Systems User Guide 553
Global Settings
To enable ARP inspection on the device:
1
Click Switching > Dynamic ARP Inspection > Global Settings in the
tree view to display the
Global Settings page.
Figure 18-1. Global Settings
2 Enter the fields:
•
Enable ARP Inspection — Enable/disable ARP inspection.
•
ARP Inspection Validate — Enable/disable the following checking
source MAC address, destination MAC address and IP addresses
against the respective addresses in the ARP body.
•
Minimal Syslog Interval (0 – 86400) — Enter the minimum time
interval between successive ARP SYSLOG messages.