Dell POWERCONNECT 5524P - Page 205

Dell PowerConnect 55xx Systems User Guide 205
The previously-assigned IP addresses are displayed.
2 To add an IP address to an interface, click Add , and enter the fields:
–
IP Address — Enter the IP address assigned to the interface.
–
Network Mask — Select the subnetwork mask to which traffic can be
routed.
–
Prefix Length — Enter the number of bits that comprise the IP
address prefix of the subnetwork.
–
Interface — Select the interface for which the IP address is defined.
Select an interface type
Port , LAG , or VLAN and the specific
interface number.
Defining IPv4 Interfaces Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the IPv4 Interfaces Parameters page.
Table 9-18. IPv4 Interface Parameters CLI Commands
CLI Command Description
ip address ip-address
{mask|prefix-length}
no ip address [ip-address]
Sets an IP address.
Use the no form of the command to
remove an IP address.
show ip interface
[[gigabitethernet|tengigabitet
hernet]port-number|vlan vlan-
id|port-channel LAG-number]
Displays the usability status of
interfaces configured for IP.