244 Dell PowerConnect 55xx Systems User Guide
Configuring ARP Using the CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the ARP pages.
The following is an example of the CLI commands:
Table 9-36. ARP CLI Commands
CLI Command Description
arp ip_addr mac_addr
{[gigabitethernet|tengigabit
ethernet] port-number|vlan
vlan-id|port-channel LAG-
number}
Adds a permanent entry in the ARP
cache.
no arp ip-address Removes an ARP entry from the ARP
Ta bl e .
arp timeout seconds Configures how long an entry remains in
the ARP cache. This command can be
used in Global Configuration mode for all
interfaces, or in Interface Configuration
mode for a specific interface.
clear arp-cache Deletes all dynamic entries from the ARP
cache
show arp Displays entries in the ARP Table.
show arp configuration Displays the global and interface
configuration of the ARP protocol
console(config)# arp 198.133.219.232 00-00-0c-40-0f-bc
console(config)# arp timeout 12000
console(config)# exit
console# show arp
ARP timeout: 12000 Seconds
Interface IP Address HW Address Status
--------- ---------- ---------- ------
gi1/0/11 10.7.1.102 00:10:B5:04:DB:4B dynamic
gi1/0/12 10.7.1.135 00:50:22:00:2A:A4 static
To Next Page
Loading...
