Dell POWERCONNECT 5524P - Page 316

316 Dell PowerConnect 55xx Systems User Guide
– Security Model — Select the SNMP version of the group.
–
Security Level — Select the security level attached to the group.
Security levels apply to SNMPv3 only. The possible options are:
•
No Authentication — Neither authentication nor the privacy
security levels are assigned to the group.
•
Authentication — Authenticates SNMP messages, and ensures
that the origin of the SNMP message is authenticated.
•
Privacy — Encrypts SNMP message.
–
Operation — Select the group access rights. The possible options are:
•
Read — The management access is restricted to read-only, and
changes cannot be made to the assigned SNMP view. If desired,
select a view from the drop-down list.
•
Write — The management access is read-write and changes can
be made to the assigned SNMP view. If desired, select a view from
the drop-down list.
•
Notify — Sends traps for the assigned SNMP view. If desired,
select a view from the drop-down list.
Defining SNMP Access Control Using CLI Commands
The following table summarizes the CLI commands for defining fields
displayed in the Access Control pages.
Table 9-58. SNMP Access Control CLI Commands
CLI Command Description
snmp-server group groupname
{v1|v2|v3 {noauth|auth|priv}}
[read readview] [write
writeview] [notify notifyview]
no snmp-server group groupname
{v1|v2|v3 [noauth|auth|priv]}
[context-name]
Configure a new Simple Network
Management Protocol (SNMP)
group, or a table that maps SNMP
users to SNMP views.
Use the no form of this command to
remove a specified SNMP group.
show snmp groups [groupname] Displays the configuration of groups