Dell POWERCONNECT 5524P - Page 328

328 Dell PowerConnect 55xx Systems User Guide
– Link Local Interface — When the server supports an IPv6 Link Local
address, this specifies the Link Local interface. The possible options
are:
•
VLAN — The IPv6 interface is configured on this VLAN.
•
ISATAP — The IPv6 interface is configured on an ISATAP
tunnel.
–
Recipient IP — The IP address to whom the traps are sent.
–
Notification Type — The notification sent. The possible options are:
•
Trap — Traps are sent.
•
Inform — Informs are sent.
If SNMP versions 1 and 2 are enabled for the selected recipient, enter the
fields:
–
Community String — The community string of the trap manager.
–
Notification Version — The message trap SNMP version (v1 or v2).
If SNMPv3 is used to send and receive traps, enter the fields:
–
User Name — The user to whom SNMP notifications are sent.
–
Security Level — The means by which the packet is authenticated.
The possible options are:
•
No Authentication — The packet is neither authenticated nor
encrypted.
•
Authentication — The packet is authenticated.
•
Privacy — The packet is both authenticated and encrypted.
3 Enter the fields for all versions of SNMP:
–
UDP Port (1-65535) — The UDP port used to send notifications. The
default is 162.
–
Filter Name — Select an SNMP filter from a list of previously-defined
SNMP filters.
–
Timeout (1-300) — The amount of time (seconds) the device waits
before resending informs.
–
Retries (1-255) — The amount of times the device resends an inform
request.